Legal notices:
- This sample program is intended as a demonstration only.
- The program is available on an 'as-is' basis with no warranties, either expressed or implied, of any kind.
- You may use the program only at your own risk.
- No license or rights to the program are either given or forfeited.
Everything that follows is direct and unaltered output from the LISP Generator.

; This program was created on December 8 2006 using the LISP Generator.

; Define the function (the program).
(defun c:SPINNER ( / SS1 I OBJ J PT1 OLDCE OLDERR OLDTE)
  ; Save the current value of cmdecho then redefine it.
  (setq OLDCE (getvar "cmdecho"))
  (setvar "cmdecho" 1)
  ; Save the current value of texteval then set it to 1
  (setq OLDTE (getvar "texteval"))
  (setvar "texteval" 1)
  ; Save the current value of the error handling subroutine then redefine it.
  (setq OLDERR *error*)
  (defun *error* (errmes)
    (princ (strcat "\nExecution of SPINNER halted by the following error: " ERRMES))
    (setvar "cmdecho" OLDCE)
    (setq *error* OLDERR)
    (prin1)
  )
  ;(setq *error* nil)
  ; NOTE: to turn error handling off, erase the semicolon in the line above.

  ; GET a SELECTION from the user and store it in SS1.
  (princ "\nSelect objects to rotate: ")
  (setq SS1 (ssget))

  ; BEGIN LOOP loop1.
  ; LOOP 36 times.
  (setq I -1)
  (repeat 36
    (setq I (1+ I))

    ; BEGIN LOOP loop2.
    ; LOOP by STEPPING THROUGH the OBJECTS of SELECTION-SET SS1, reading them into OBJ.
    (setq J -1)
    (while (setq OBJ (ssname SS1 (setq J (1+ J))))

      ; EXTRACT the Start point from the entity OBJ and store it in PT1.
      (setq PT1 (cdr (assoc 10 (entget OBJ))))

      ; Input to AutoCAD's command line.
      (command
        "rotate"
        OBJ
        ""
        PT1
        "10"
      )

    ) ; END LOOP loop2.
  ) ; END LOOP loop1.
  ; Reset "cmdecho" to previous value.
  (setvar "cmdecho" OLDCE)
  ; Reset "texteval" to previous value.
  (setvar "texteval" OLDTE)
  ; Reset *error* to previous definition.
  (setq *error* OLDERR)
  ; Exit quietly (no return value.)
  (prin1)
)